206P

The SEM206 is our entry level PC programmable temperature transmitter. There are three versions for Pt100, Thermocouple and Thermistor sensors. It will convert the sensor output to a standard industrial (4 to 20) mA transmission signal. PC configuration allows the user to select range, units and burnout direction, without requiring calibration equipment. Configuration is performed quickly using our USB port driven configurator by simply connecting two clips to the SEM206 loop terminals and following the software instructions. Calibration set up may be saved as a file on the PC for later use.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUT
Sensor Type PT100 100R @ 0°C 2 or 3 Wire
Sensor Range (-200 to +850) °C (18 to 390) :
Sensor Connection Screw terminal
Minimum span (*1) 25 °C
Linearisation BS EN 60751(IEC 751) standard /JISC 1604
Measurement Accuracy (*2) 0.1 °C +/-0.05% of Reading
Thermal Drift 25ppm/ °C
Excitation current Lead Resistance effect 0.002 °C / Ohm
Maximum lead Resistance 20 ohms per leg
OUTPUT
Output Type 2 wire 4 to 20 mA current loop
Output range (4.0 to 20.0) mA
Output Connection Screw Terminal
Maximum output 21.5mA (in high burnout condition)
Minimum output 3.8 mA (in low burnout condition)
Accuracy (mA output /2000) or 5uA
(Which ever is the greater)
Loop Voltage effect 0.2 uA / V
Thermal drift 1 uA / °C
Maximum output load [(Vsupply-10)/20]K Ohms
(Example: 700 ohms @ 24V)
GENERAL SPECIFICATION
Update time 500 mS
Response Time 1 second
Start up time 4 Seconds ( I out < 4 mA during
start up)
Warm-up time 1 minutes to full accuracy
Power Supply 10 to 30 Volts dc

 

datasheet